SAFETY DATA SHEET
SDS No. I.SF.1
Section 1 – Product Identification
Product Use Description:
Polyurethane Injection Grout
505 BLUE BALL RD. #160
ELKTON, MD 21921
24 hr Emergency Phone: Chem-Tel (800) 255-3924
Information Phone No.
Recommended use of the chemical and restriction on use:
Refer to the product technical data sheet.
For industrial and professional users.
Section 2 – Hazards Identification
Skin irritation, Category 2
Skin sensitization, Category 1
Eye irritation, Category 2A
Acute toxicity, inhalation, Category 4
Sensitization, respiratory, Category 1
Respiratory tract irritation, Category 3
Specific target organ toxicity, repeated exposure, Category 2
GHS Label element:
Causes skin irritation.
May cause an allergic skin reaction.
Causes serious eye irritation.
Harmful if inhaled.
May cause allergy or asthma symptoms or breathing difficulties if inhaled.
May cause respiratory irritation.
May damage fertility or the unborn child.
May cause damage to respiratory system through prolonged or repeated exposure.
Keep out of reach of children.
Do not breathe mist, vapours or spray.
Wash skin thoroughly after handling.
Do not eat, drink or smoke when using this product.
Use only outdoors or in a well-ventilated area.
Wear protective gloves/protective clothing/eye protection/face protection.
In case of inadequate ventilation wear respiratory protection.
Page 1 of 6
P302 + P352:
P333 + P313:
P304 + P340:
P337 + P313
P308 + P313:
Wash with plenty of soap and water.
IF SKIN irritation or rash occurs: Get medical attention.
Take off contaminated clothing and wash before reuse.
IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable
If experiencing respiratory symptoms: call a POISON CENTER or
IF IN EYES:
Rinse cautiously with water for several minutes. Remove contact
lenses, if present and easy to do. Continue rinsing.
IF eye irritation persists, get medical advice/attention.
IF exposed or concerned, get medical advice.
P403 + P410:
Store in a well-ventilated place. Protect from sunlight.
Store locked up.
Dispose of contents/container to an approved waste disposal site.
P342 + P311:
P305 + P351 + P338:
IF ON SKIN:
Section 3 – Composition / Information on Hazardous Ingredients
Polymeric diphenylmethane diisocyanate
30 - 60
30 - 60
Note: There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting in
Section 4 – First Aid Measures
Supply fresh air and consult a physician if breathing becomes difficult. Symptoms may be
delayed for several hours.
If person is conscious, wash out mouth with water. Do not induce vomiting unless
instructed to do so by a poison center or physician.
Immediately flush skin with plenty of water. Do not use solvents or thinners. Remove
contaminated clothing and shoes. Seek medical advice if irritation or rash occurs. Wash
clothing before reuse.
Immediately flush eyes with plenty of water for at least 15 minutes, lifting upper and lower
eyelids occasionally. Remove contact lenses, if present. Seek medical attention if irritation
Section 5 – Fire Fighting Measures
Water fog, foam, dry chemical or carbon dioxide.
Fire Fighting Procedures:
Standard. As in any fire, wear self-contained breathing apparatus
pressure-demand, MSHA/NIOSH (approved or equivalent) and full
protective gear. Containers can build up pressure if exposed to heat
(fire). Cool with water spray. Do not scatter material with high pressure
Page 2 of 6
Hazardous Combustion Products:
Carbon oxides, nitrogen oxides, isocyanates and trace amounts of
Unusual Fire and Explosion Hazards: Water contamination produces carbon dioxide gas. This may cause
pressurization or explosion of containers.
Section 6 – Accidental Release Measures
Person-related Safety Precautions:
Provide plenty of fresh air. Avoid eye and skin contact. Avoid inhalation
of vapors. Wear personal protective equipment. Remove or eliminate all
Methods for cleaning-up:
Prevent from entering into soil, ditches, sewers, waterways and/or
groundwater. Small spills: Absorb with dry chemical absorbent, earth,
sand or any other inert material. Allow to stand uncovered for 48 hrs.
before closing container. Large spills: Create a dike or trench to contain
product. Follow same procedure as for a small spill.
Clean spill area with a decontamination solution. Suggested formulation:
Sodium carbonate (5-10%), liquid detergent (1-2%), water (88-94%).
Alternate formulation: Concentrated ammonia (3-8%), liquid detergent
(1-2%), water (90-96%). Ensure adequate ventilation to prevent
overexposure of ammonia.
Waste Disposal Method:
Dispose in accordance with local, state and federal regulations.
Do not allow product to reach ground water, bodies of water, or storm
water or sewage systems.
Section 7 – Handling and Storage
Avoid contact with eyes, skin and clothing. Wash thoroughly after handling.
Follow all SDS/label precautions even after the container is emptied because it
may retain product residues. Use only with adequate ventilation. Keep container
closed when not in use. Do not reseal if contaminated. Keep away from heat and
Keep container tightly closed when not in use. Do not store in direct sunlight.
4oC – 32oC (~40oF - ~90oF).
Section 8 – Exposure Controls / Personal Protection
0.02 ppm (Ceiling)
0.20 mg/m3 (Ceiling)
Use adequate ventilation.
Use local exhaust ventilation. For airborne exposure above exposure limit(s),
wear a NIOSH approved air-purifying respirator equipped with organic vapor
cartridges. For situations where the atmospheric levels may exceed the level for
which an air-purifying respirator is effective, use a positive-pressure air-supplying
Page 3 of 6
Wear chemical resistant protective clothing and footwear impervious to the
product if there is a potential for skin contact.
Use safety goggles or face shield.
Other Protective Equipment: A safety shower and eye wash fountain should be readily available.
Wash hands before breaks and after work, and before eating, drinking or
Section 9 – Physical and Chemical Properties
Solubility in water:
Specific Gravity (water = 1) at 25oC:
Viscosity, (kinematic) at 25oC:
Auto ignition Temperature:
Lower explosion Limit:
Upper explosion Limit:
Insoluble, reacts with water
>93°C (>200°F) (closed cup)
<0.0001 mmHg at 25oC (77OF)
1.22 – 1.24 g/cm3
200 - 300 cps
No data available
No data available
No data available
Section 10 – Stability and Reactivity
Hazardous Decomposition Products: Carbon oxides, nitrogen oxides, isocyanides and trace amounts of
Can be caused by elevated temperatures.
This product will react with any materials containing active hydrogens
such as water, alcohol, amines, bases and acids. The reaction with
water is very slow under 50oC (122oF), but is accelerated at higher
Section 11 – Toxicological Information
IARC: Not regulated as a carcinogen.
Not regulated as a carcinogen.
OSHA: Not regulated as a carcinogen.
Section 12 – Ecological Information
Page 4 of 6
>9400 mg/kg (rabbit).
>10000 mg/kg (rat).
0.49 mg/L/4 h (rat) (respirable aerosol).
LC50 >500 mg/L/96h (zebra fish).
EC50 >500 mg/L/24 h (daphnia magna).
Section 13 – Disposal Considerations
Must be disposed of in a manner consistent with federal, state and local regulations.
when cartridge is empty dispose with trash.
RCRA/EPA Waste Information: If discarded in its purchased form, this material is not a RCRA hazardous waste.
Section 14 – Transport Information
USDOT (Domestic Surface):
Section 15 – Regulatory Information
TSCA (Toxic Substances Control Act):
All components are on TSCA inventory.
If discarded in its purchased form, this material is not a RCRA hazardous waste.
US Federal Regulatory Information:
SARA Title III (Superfund Amendments and Reauthorization Act:
311/312 Hazard Categories:
Acute, Chronic, Reactive.
313 Reportable Components:
Diphenylmethane 4,4’-diisocyanate (Category Diisocyanate Compounds)
Polymeric diphenylmethane diisocyanate (Category Diisocyanate Compounds)
CERCLA (Comprehensive Environmental Response and Liability Act)
National Response Center:
Any spill or release to the environment above RQ must be reported to the
National Response Center (800-424-8802).
Section 16 – Other Information
Abbreviations and acronyms:
United States Department of Transportation.
International Maritime Code for Dangerous Goods.
International Air Transport Association.
Chemical Abstracts Service (Division of the American Chemical Society).
Lethal concentration, 50 percent.
Page 5 of 6
SAFETY DATA SHEET
Lethal dose, 50 percent.
Median effective concentration.
SDS prepared by:
Aquafin product safety department.
We believe the statements, technical information and recommendations contained herein are reliable, but they are
given without warranty or guarantee of any kind, expressed or implied, and we assume no responsibility for any
loss, damage, or expense, direct or consequential, arising out of their use. Aquafin shall not be responsible for the
use of this product in a manner to infringe on any patent or any other intellectual property rights held by others.
User is responsible for determining appropriate safety measures and for applying the legislation covering his own
activities. We recommend that user makes tests to determine the suitability of a product for its particular purpose
prior to use.
END OF SDS
Page 6 of 6
(March 21, 2019)