SAFETY DATA SHEET
SDS No. E.1.2.1
SDS No. E.1.2.1
Section 1 – Product Identification
Product Use Description:
Accelerant for PU injection resin
505 BLUE BALL RD. #160
ELKTON, MD 21921
Emergency Phone No.
Information Phone No.
Recommended use of the chemical and restriction on use:
Refer to the product technical data sheet.
For industrial and professional users.
Section 2 – Hazards Identification
Skin Corr. 1B
Eye Dam. 1
Acute Tox. 4
H314 Causes severe skin burns and eye damage.
H318 Causes serious eye damage.
H302 Harmful if swallowed.
GHS Label element:
H302 Harmful if swallowed
H314 Causes severe skin burns and eye damage
H318 Causes serious eye damage
P260 Do not breathe dust/fume/gas/mist/vapors/spray
P280 Wear protective gloves/protective clothing/eye protection/face protection
P282 Wear face shield/eye protection
P264 Wash … thoroughly after handling
P270 Do not eat, drink or smoke when using this product
P302 + P362 + P353
P305 + P351 + P338
P301 + P312 + P330
P304 + P340
IF ON SKIN: P362 Take off contaminated clothing and wash before reuse. Rinse skin
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses,
if present and easy to do. Continue rinsing.
IF SWALLOWED: Call a POISON CENTER/doctor if you feel unwell. Rinse mouth.
Do NOT induce vomiting
IF INHALED: Remove person to fresh air and keep comfortable for breathing.
Wash contaminated clothing before reuse.
Page 1 of 6
Store in a closed container. Store locked up.
Dispose of contents/container in accordance with local/regional/national/international
Section 3 – Composition / Information on Ingredients
Description: Mixture of the substances listed below with nonhazardous additions.
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence not require reporting
in this section.
Section 4 – First Aid Measures
General Information: Immediately remove any clothing soiled by the product. Symptoms of poisoning may even
occur after several hours; therefore, medical observation is suggested for at least 48
hours after the accident.
In case of unconsciousness place patient stably in side position for transportation.
Immediately seek medical attention. Do not induce vomiting without medical advice. If
conscious, drink plenty of water.
After Skin Contact:
Immediately wash with water and soap and rinse thoroughly.
After Eye Contact:
Rinse opened eye for several minutes under running water. Then consult a doctor.
Section 5 – Fire Fighting Measures
Carbon Dioxide (CO2), extinguishing powder or water spray. Fight larger
fires with water spray or alcohol resistant foam
Special Fire Fighting Procedures:
As in any fire, wear full protective gear and NIOSH-approved selfcontained breathing apparatus with full face-piece operated in the
pressure demand or other positive pressure mode.
Section 6 – Accidental Release Measures
Personal Safety Precautions:
Wear protective equipment. Keep unprotected persons away.
Do not allow to enter sewers/ surface or ground water. Inform respective
authorities in case of seepage into water course or sewage system.
Methods for Cleaning up:
Absorb with liquid-binding material (sand, diatomite, acid binders,
universal binders, sawdust). Use neutralizing agent. Dispose
contaminated material as waste according to item 13. Ensure adequate
Page 2 of 6
Section 7 – Handling and Storage
Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols.
Store in an enclosed area in tightly closed containers.
Section 8 – Exposure Controls / Personal Protection
Use with adequate general and local exhaust ventilation.
Avoid contact with the skin. Immediately remove all soiled and contaminated
Wear tightly sealed goggles. Avoid contact with the eyes. .
Keep away from foodstuffs, beverages and feed. Wash hands before breaks and
at the end of work.
In case of brief exposure or low pollution use respiratory filter device. In case of
intensive or longer exposure use respiratory protective device that is independent
of circulating air.
The glove material has to be impermeable and resistant to the product/ the
substance/ the preparation.
Section 9 – Physical and Chemical Properties
Solubility in water:
pH (in water):
Not miscible or difficult to mix.
Product is not self-igniting
No VOCs. 0.0 g/l / 0.00 lb/gl
Section 10 – Stability and Reactivity
Stable under normal temperatures and pressures.
Conditions to Avoid:
No further relevant information available.
Hazardous Decomposition Products: No dangerous decomposition products known.
Section 11 – Toxicological Information
LD50 301 - 2000 mg/kg (rat)
Page 3 of 6
Primary irritant effect:
On the skin: Strong caustic effect on skin and mucous membranes.
On the eye:
Strong caustic effect.
Sensitization: No sensitizing effects known.
Additional toxicological information:
The product shows the following dangers according to internally approved calculation methods for
Swallowing will lead to a strong caustic effect on mouth and throat and to the danger of perforation of
esophagus and stomach.
IARC: Not regulated as a carcinogen.
Not regulated as a carcinogen.
OSHA: Not regulated as a carcinogen.
Section 12 – Ecological Information
Aquatic toxicity: 112-69-6
Very toxic for fish
Additional ecological information:
Water hazard class 2 (Self-assessment): hazardous for water. Do not allow
product to reach ground water, water course or sewage system. Must not
reach bodies of water or drainage ditch undiluted or unneutralized. Danger to
drinking water, if even small quantities leak into the ground. Also poisonous
for fish and plankton in water bodies. Very toxic for aquatic organisms.
Section 13 – Disposal Considerations
Waste Disposal Method:
Recommendation: Must not be disposed of together with household garbage. Do
not allow product to reach sewage system.
Disposal must be made according to official regulations.
Section 14 – Transport Information
UN-Number: DOT, IMDG, IATA
UN Proper Shipping Name:
Amines, liquid, corrosive, n.o.s. (Hexadecyldimethylamine)
A M I N E S , L I Q U I D , C O R R O S I V E , N . O . S . (Hexadecyldimethylamine),
A M I N E S , L I Q U I D , C O R R O S I V E , N . O . S . (Hexadecyldimethylamine)
Transport Hazard Class:
USDOT (Domestic Surface)
IMDG (Ocean) Hazard Class or Division:
IATA/ICAO (Air) Hazard Class or Division:
8 Corrosive substances
8 Corrosive substances
8 Corrosive substances
Page 4 of 6
Label Packaging Group
Special precautions for user
Danger code (Kemler)
Product contains environmentally hazardous substances:
Symbol (fish and tree)
Warning: Corrosive substances
SG35 Stow "separated from" acids.
Transport in bulk according to Annex II of MARPOL73/78 and the IBC Code: Not applicable.
On passenger aircraft/rail: 1 L
On cargo aircraft only: 30 L
Special marking with the symbol (fish and tree).
Limited quantities (LQ)
Excepted quantities (EQ) Code:
UN "Model Regulation":
Maximum net quantity per inner packaging: 30 ml
Maximum net quantity per outer packaging: 1000 ml
UN 2 735 AMINES , LIQUID, CORROSIVE, N.O.S.
Section 15 – Regulatory Information
SARA 355 (Extremely Hazardous Substances): None of the ingredients is listed.
SARA Section 313 Notification:
TSCA (Toxic Substances Control Act):
None of the ingredients is listed.
No CERCLA chemicals exist in this product above reportable
California Proposition 65: Warning – This product contains a chemical known to the State of California to
Section 16 – Other Information
Abbreviations and acronyms:
United States Department of Transportation.
International Maritime Code for Dangerous Goods.
International Air Transport Association.
Page 5 of 6
Chemical Abstracts Service (Division of the American Chemical Society).
Hazardous Materials Identification System (USA)
Lethal concentration, 50 percent.
Lethal dose, 50 percent.
National Institute for Occupational Safety
Occupational Safety & Health
Threshold Limit Value
Permissible Exposure Limit
Recommended Exposure Limit
SDS prepared by:
Aquafin product safety department.
We believe the statements, technical information and recommendations contained herein are reliable, but they are
given without warranty or guarantee of any kind, expressed or implied, and we assume no responsibility for any
loss, damage, or expense, direct or consequential, arising out of their use. Aquafin shall not be responsible for the
use of this product in a manner to infringe on any patent or any other intellectual property rights held by others.
(April 09, 2015)
User is responsible for determining appropriate
measures and for applying the legislation
covering his own
activities. We recommend that user makes tests to determine the suitability of a product for its particular purpose
prior to use.
END OF SDS
Page 6 of 6
(January 24, 2019)