SAFETY DATA SHEET
AQUAFIN JOINT TAPES + GASKET
SDS No. 3.1.1.
Section 1 – Product Identification
AQUAFIN JOINT SEALING TAPE-2000 + 2000-S,
505 BLUE BALL RD. #160
ELKTON, MD 21921
Polyolefin elastomeric tape + gasket
Emergency Phone No.
Information Phone No.
Recommended use of the chemical and restriction on use:
Refer to the product technical data sheet.
For industrial and professional users.
Section 2 – Hazards Identification
GHS Classification: Not classified.
GHS Label element:
Hazard Pictograms: None.
Store in a dry place.
Dispose of contents to an approved waste disposal site.
Section 3 – Composition / Information on Ingredients
Product is chemically non-hazardous and non-toxic.
Section 4 – First Aid Measures
Ingestion of this product is unlikely.
Wash with mild soap and water.
Flush with warm running water for at least 15 minutes, lifting upper and lower eyelids
occasionally. Do not rub if irritation persists. Seek medical attention.
Section 5 – Fire Fighting Measures
Fire Fighting Equipment:
Use self-contained breathing apparatus and body covering. Approach fire from
downside of wind.
Page 1 of 3
SAFETY DATA SHEET
SDS No. 3.1.1.
Water, water spray, dry chemical, carbon dioxide, foam.
Unusual Fire and Explosion Hazards: Product releases carbon dioxide (CO2), carbon monoxide (CO), nitrogen
oxide (NOX), and depending on intensity of fire, hydrocarbon CNHN) and
hydrogen cyanide (HCN) appear.
Section 6 – Accidental Release Measures
Waste Disposal Method:
Dispose of in accordance with local, state and federal regulations.
Section 7 – Handling and Storage
Keep out of reach of children. No special handling precautions needed.
Store in a dry place away from direct sunlight.
Section 8 – Exposure Controls / Personal Protection
General (mechanical) room ventilation is expected to be satisfactory.
In well ventilated areas not necessary.
Cotton or cotton/synthetic overalls are suitable.
Handle using good industrial hygiene and safety practices. Wash hands before
breaks and after work, and before eating, drinking or smoking. Change and
launder work clothes after use.
Section 9 – Physical and Chemical Properties
Appearance / Color:
Solubility in water:
Elastomeric tape & sheet
Elastomer embedded in white backing fabric
N/A (Not Applicable)
120 - 180 C (250 - 355 F)
Section 10 – Stability and Reactivity
Stable under normal temperatures and pressures.
Hazardous Decomposition Products: Under normal conditions of storage and use, hazardous decomposition
products should not be produced.
Strong acids, strong bases, strong oxidizing agents.
Section 11 – Toxicological Information
When applied in accordance with manufacturer’s instructions, no toxicological risks
Page 2 of 3
Section 12 – Ecological Information
Section 13 – Disposal Considerations
Dispose of in a manner consistent with federal, state and local regulations.
Section 14 – Transport Information
USDOT (Domestic Surface)
IMDG (Ocean) Hazard Class or Division:
IATA/ICAO (Air) Hazard Class or Division:
Section 15 – Regulatory Information
All components listed on or exempt from TSCA master list inventory.
This product is not deemed hazardous as defined by OSHA 29CFR part
California Proposition 65:
This product does not contain any ingredients subject to California Proposition 65.
Section 16 – Other Information
0 = Minimal;
HMIS III rating:
1 = Slight;
2 = Moderate;
Physical hazard: 0
3 = Serious;
4 = Severe; * = Chronic)
Personal Protection: A
Abbreviations and acronyms:
United States Department of Transportation.
International Maritime Code for Dangerous Goods.
International Air Transport Association.
Chemical Abstracts Service (Division of the American Chemical Society).
SDS prepared by:
Aquafin product safety department.
DISCLAIMER: We believe the statements, technical information and recommendations contained herein are
reliable, but they are given without warranty or guarantee of any kind, expressed or implied, and we assume no
responsibility for any loss, damage, or expense, direct or consequential, arising out of their use. Aquafin shall not
be responsible for the use of this product in a manner to infringe on any patent or any other intellectual property
rights held by others. User is responsible for determining appropriate safety measures and for applying the
legislation covering his own activities. We recommend that user makes tests to determine the suitability of a
product for its particular purpose prior to use.
(March 13, 2019)
Page 3 of 3