IDENTITY:
SAFETY DATA SHEET
TM
Pavemend Instant Asphalt
Date prepared: Date revised:
SDS No. PV.1.6
MAY 2016 FEBUARY 2019
Section 1 – Product Identification IDENTITY:
Pavemend Instant AsphaltTM (4.0, 6.0 & 9.0)
Product Name:
Product Use Description:
AQUAFIN, INC. 505 BLUE BALL RD. #160 ELKTON, MD 21921
Chemical Characterization: Cold Asphalt Mix Water activated, solvent free, cold applied asphalt repair material
Emergency Phone No. Information Phone No.
info@aquafin.net
www.aquafin.net
Recommended use of the chemical and restriction on use:
(800) 394-1410 (410) 392-2300
Refer to the product technical data sheet. For industrial and professional users.
Section 2 – Hazards Identification GHS Classification: Skin irritation, Category 2 Serious eye damage, Category 1 Respiratory system; Category 3 Carcinogenity, Category 1A
H315: H318: H335: H350:
Causes skin irritation (alkaline when moistened) Causes serious eye damage May cause respiratory irritation May cause cancer
GHS Label element: Hazard Pictograms GHS07
Signal Word:
Warning
Hazard Statements: H316: H320:
Causes mild skin irritation. Causes eye irritation.
Precautionary Statements: Prevention: P264: Wash skin thoroughly after handling. P280: Wear protective gloves/protective clothing/eye protection/face protection. Response: P302 + P352:
P332 + P313: P362:
Wash with plenty of soap and water. Not relevant. Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. IF skin irritation occurs, Get medical advice/attention. Take off contaminated clothing and wash before reuse.
Storage: P403 + P232:
Store in a well-ventilated place. Protect from moisture.
P305 + P351 + P338:
IF ON SKIN: IF INHALED: IF IN EYES:
Page 1 of 5
Disposal: P501:
Dispose of contents/container to an approved waste disposal site.
Section 3 – Composition / Information on Ingredients Hazardous Components Mineral aggregates Bitumen-Binder HAZARDS DISCLOSURE:
CAS No. Not Applicable 8052-42-4
Percent % 90 – 96, no dust, encapsulated with binder 4-9
This product contains no known hazardous materials as defined by the OSHA Hazard Communication Standard 29 CFR 1910-1200.
Section 4 – First Aid Measures Inhalation:
Not relevant.
Ingestion:
Drink copious amounts of water and provide fresh air. Consult a physician immediately. Do not induce vomiting without medical advice. If a person vomits, place him/her in the recovery position. Never give anything by mouth to an unconscious person.
Skin Contact: Rinse skin with warm water. Seek medical attention if irritation persists. Wash contaminated clothing before reuse. Eye Contact:
Rinse opened eye with plenty of running water for at least 15 minutes, lifting upper and lower eyelids occasionally. Consult physician.
Section 5 – Fire Fighting Measures Auto ignition Temperature:
Not combustible.
Hazardous combustion Products:
Not applicable.
Extinguishing Media:
Water, foam, CO2, extinguishing powder or water mist.
Special Fire Fighting Procedures:
In the event of a fire, wear full protective clothing and NIOSHapproved self-contained breathing apparatus with full face-piece operated in the pressure demand or other positive pressure mode.
Unusual Fire and Explosion Hazards: Cool closed containers exposed to fire with water spray.
Section 6 – Accidental Release Measures Measures for Cleaning/Collecting:
No special measures required.
Environmental Precautionary Measures: Observe usual precautions. Methods for Cleaning up:
Collect mechanically.
Other information:
Spills of this material do not need to be reported to the National Response Center.
Page 2 of 5
Section 7 – Handling and Storage Handling:
Avoid contact with skin, eyes and clothing. Keep out of reach of children. Keep away from heat, sparks, flame and direct sunlight. Do not smoke. Do not store open containers. No special measures required.
Storage:
No special storage precautions needed. Store in original container, away from foodstuffs. Store containers tightly closed in a cool, well ventilated place.
Section 8 – Exposure Controls / Personal Protection General Information:
The product does not contain any relevant quantities of materials that have to be monitored at the workplace.
Respiratory Protection:
Not required.
Skin Protection:
When installing, wear appropriate protective gloves (butyl, rubber) to prevent hand-skin exposure. Wear appropriate impervious clothing to prevent skin exposure (long sleeve shirt and long pants).
Eye Protection:
Wear safety glasses with side shields or goggles.
Work/Hygienic Practices:
Handle using good industrial hygiene and safety practices. Keep work area clean. Wash hands before breaks and after work, and before eating, drinking or smoking.
Section 9 – Physical and Chemical Properties Physical State: Appearance/Color: Odor: Solubility in water: Flash Point: Flammability: Lower Explosion Limit: Upper Explosion Limit: Danger of Explosion (°C): Fire Promoting Properties (°C): pH-value at 20°C: Boiling Point: Freezing Point: Specific Gravity (Density): Viscosity, dynamic at 20°C: Concentration as applied:
Solid, mineral binder, mix Black Weak, characteristic Not relevant Not relevant Not relevant N/A N/A Product is not explosive Product is not oxidizing Not relevant Not relevant Not relevant 3 2-2.5 kg/dm Not relevant 0 g/L
Section 10 – Stability and Reactivity Chemical Stability:
Stable.
Hazardous Reactions:
Will not occur.
Conditions to Avoid:
Keep away from heat and sparks.
Thermal Decomposition:
Not relevant. Page 3 of 5
Section 11 – Toxicological Information Acute Effects:
The product is classified as not acute toxic.
Chronic Effects:
The product is classified as not sub-acute respectively chronic toxic.
Corrosive or Irritant Effect or Sensitization: The product is classified as not irritating or sensitizing. Likely Routes of Exposure: • Skin: • • • •
Eye contact, skin contact. Prolonged exposure may cause moderate skin irritation. May cause drying/defatting of the skin. Eye: Causes mild/moderate irritation (tears, blurred vision and redness). Ingestion: Not likely to be toxic but may cause irritation of the mouth, throat and stomach. Inhalation: Not relevant. Medical Conditions Aggravated by Exposure: May cause more significant skin irritation in people with preexisting skin conditions.
Section 12 – Ecological Information Mobility in Environment:
Persistence/Degradability:
Bioaccumulation/Accumulation: Not relevant. Further Negative Effects:
There are no negative effects known.
Section 13 – Disposal Considerations Recommendations:
Use excess product in an alternate beneficial application.
Disposal:
Dispose pf in a manner consistent with federal, state and local regulations.
Packaging:
Empty containers can be reused or recycled after cleaning. Note local restrictions.
Section 14 – Transport Information USDOT (Domestic Surface) IMDG/IMO (Ocean) Hazard Class or Division: IATA/ICAO (Air) Hazard Class or Division: TDG (Canada ground):
Not regulated Not regulated Not regulated Not regulated
Section 15 – Regulatory Information OSHA Process Safety (29CFR 1910.119):
Not regulated.
TSCA Status: All ingredients are on the inventory or exempt from listing.
Page 4 of 5
Section 16 – Other Information (Hazard Rating:
0 = Minimal;
HMIS III rating: Health: 0 Flammability: 0
1 = Slight;
2 = Moderate;
Physical hazard: 0
3 = Serious;
4 = Severe; * = Chronic)
Personal Protection: X
Abbreviations and acronyms: USDOT: IMDG: IATA: CAS: LC50: LD50:
United States Department of Transportation. International Maritime Code for Dangerous Goods. International Air Transport Association. Chemical Abstracts Service (Division of the American Chemical Society). Lethal concentration, 50 percent. Lethal dose, 50 percent.
SDS prepared by:
Aquafin product safety department.
DISCLAIMER: We believe the statements, technical information and recommendations contained herein are reliable, but they are given without warranty or guarantee of any kind, expressed or implied, and we assume no responsibility for any loss, damage, or expense, direct or consequential, arising out of their use. Aquafin shall not be responsible for the use of this product in a manner to infringe on any patent or any other intellectual property rights held by others. User is responsible for determining appropriate measures and for applying the legislation covering his own END OFsafety MSDS (April 09, 2015) activities. We recommend that user makes tests to determine the suitability of a product for its particular purpose prior to use. END OF SDS
Page 5 of 5
(February 12, 2019)