IDENTITY:
SAFETY DATA SHEET
Waterstop-Strip
Date prepared: Date revised:
SDS No. 5.1.4.C1
APRIL 2013 JANUARY 2019
SDS No.5.1.4.C1
Section 1 – Product Identification IDENTITY:
Product Name: Chemical Characterization:
Thermoplastic elastomer Hydrophilic, water activated swellable waterstop for sealing joints in concrete
AQUAFIN, INC. 505 BLUE BALL RD. #160 ELKTON, MD 21921
Emergency Phone No. Information Phone No.
(800) 394-1410 (410) 392-2300
info@aquafin.net www.aquafin.net
Recommended use of the chemical and restriction on use:
Refer to the product technical data sheet. For industrial and professional users.
Section 2 – Hazards Identification GHS Classification: Not classified. GHS Label element: Hazard Pictograms: Signal Word:
Hazard Statements:
None.
Precautionary Statements: Prevention: Not applicable. Response: Storage: P232:
Protect from moisture.
Disposal: P501: P502:
Dispose of contents to an approved waste disposal site. Refer to manufacturer/supplier for information on recovery/recycling.
Not applicable.
Section 3 – Composition / Information on Ingredients Hazardous components:
Section 4 – First Aid Measures Inhalation:
Not applicable
Ingestion:
Ingestion of this product is unlikely. However, if ingestion does occur, seek immediately/instantly medical attention. Product increases its volume 50% - 850% over time.
Skin Contact:
Wash with mild soap and water.
Eye Contact:
Flush with warm running water for at least 15 minutes, lifting upper and lower eyelids occasionally. Do not rub if irritation persists. Seek medical attention.
Page 1 of 3
Section 5 – Fire Fighting Measures Fire Fighting Equipment:
Fire fighters should wear appropriate protective equipment including NIOSH approved respirators.
Extinguishing Media:
Water, water spray, dry chemical, carbon dioxide, foam.
Special Fire Fighting Procedures:
Thermal decomposition of fabric coating may cause irritating smoke and fumes. See section 10 for additional information.
Unusual Fire and Explosion Hazards: No unusual fire or explosion hazards.
Section 6 – Accidental Release Measures General:
If product is wet, allow to dry.
Waste Disposal Method:
Remove sources of ignition Dispose of in accordance with local, state and federal regulations.
Section 7 – Handling and Storage Handling:
Keep out of reach of children. Keep away from heat and direct sunlight. No special handling precautions needed.
Storage:
Store in a dry place away from direct sunlight.
Section 8 – Exposure Controls / Personal Protection Engineering Controls:
General (mechanical) room ventilation is expected to be satisfactory.
Respiratory Protection:
In well ventilated areas not necessary.
Skin Protection:
Cotton or cotton/synthetic overalls are suitable.
Eye Protection:
Not required.
Work/Hygienic Practices:
Handle using good industrial hygiene and safety practices. Wash hands before breaks and after work, and before eating, drinking or smoking. Change and launder work clothes after use.
Section 9 – Physical and Chemical Properties Physical State: Appearance / Color: Odor: Solubility in water: pH: Boiling Point: Melting Point: Density: VOC %: Static Charge:
Thermoplastic elastomer Brownish red None Insoluble N/A (Not Applicable) N/A o o >300 C (>570 F) 3 1.25 kg/cm 0% (zero) N/A.
Section 10 – Stability and Reactivity Chemical Stability:
Stable under normal temperatures and pressures.
Hazardous Decomposition Products: Under normal conditions of storage and use, hazardous decomposition products should not be produced. Thermal Page 2 of 3
SDS No. 5.1.4.C1 o
o
decomposition starts at about 300 C (~570 F). Incompatibilities:
Strong acids, strong bases, strong oxidizing agents.
Section 11 – Toxicological Information General:
When applied in accordance with manufacturer’s instructions, no toxicological risks are expected.
Section 12 – Ecological Information Environment:
Toxic to aquatic systems. Do not allow product to reach into natural waterways, drains, and storm water or wastewater systems.
Section 13 – Disposal Considerations Waste Disposal:
Dispose of in a manner consistent with federal, state and local regulations.
Section 14 – Transport Information USDOT (Domestic Surface) IMDG (Ocean) Hazard Class or Division: IATA/ICAO (Air) Hazard Class or Division: TDG (Canada):
Not regulated Not regulated Not regulated Not regulated
Section 15 – Regulatory Information TSCA Status:
All components listed on or exempt from TSCA master list inventory.
OSHA Status:
This product is not deemed hazardous as defined by OSHA 29CFR part 1910.1200.
California Proposition 65:
This product does not contain any ingredients subject to California Proposition 65.
Section 16 – Other Information (Hazard Rating:
0 = Minimal;
HMIS III rating: Health: 0* Flammability: 0
1 = Slight;
2 = Moderate;
3 = Serious;
4 = Severe; * = Chronic)
Physical hazard: 0
Abbreviations and acronyms: USDOT: IMDG: IATA: CAS: LC50: LD50:
United States Department of Transportation. International Maritime Code for Dangerous Goods. International Air Transport Association. Chemical Abstracts Service (Division of the American Chemical Society). Lethal concentration, 50 percent. Lethal dose, 50 percent.
SDS prepared by:
Aquafin product safety department.
DISCLAIMER: We believe the statements, technical information and recommendations contained herein are reliable, but they are given without warranty or guarantee of any kind, expressed or implied, and we assume no responsibility for any loss, damage, or expense, direct or consequential, arising out of their use. Aquafin shall not be responsible for the use of this product in a manner to infringe on any patent or any other intellectual property rights held by others. User is responsible for determining appropriate safety measures and for applying the legislation covering his own activities. We recommend that user makes tests to determine the suitability of a product for its particular purpose prior to use. END OF SDS Page 3 of 3
(January 23, 2019)